INNOVENTOR MEDICAL TECHNOLOGIES
Seat Cushion Controller

• Simple Three Button Interface with Lock-Out Feature
• Uses Single, Stand Alone 9-Volt Battery
• Alternating Pressure Resolution
• Single & Multiple Channel Control
• Heater Control (as option)

The Seat Cushion Controller uses microelectronic technology to lessen the likelihood of skin breakdown and ulceration environments. This programmable, microprocessor controlled seating among seated individuals in both institutional and independent living product minimizes user/caregiver service by memorizing and maintaining your internal cushion pressure set point. The controller alarms if cushion pressure cannot be maintained for any reason. In addition, the internal cushion pressure safely and periodically alternates above and below the saved set point to dynamically increase both the overall immersion depth and total user contact area.

The Seat Cushion Controller provides a wide range of internal cushion pressure adjustments which uniformly contours the cushion to meet the needs of individual anatomical variances.  On-board memory stores the optimal internal cushion pressure as defined by Clinicians and Seating Specialists.

Alternating Pressure Resolution™ cycles the internal cushion pressure slightly above and below the set point. The main weight distribution area and immersion depth becomes greater for intermittent, dynamic reduction of interface pressure.

Benchmark quality control subroutines in the controller’s firmware code monitor the cushion and activates different audible alarms if recognizable anomalies occur that compromise user or product integrity. This code also considers fluctuations of cushion pressure from normal weight shifts and active motion to prevent false alarming.

Common, safe 9-volt DC alkaline battery is easily replaceable and lasts for months under normal use conditions. Low voltage alarm beeps when change of battery is required.

The Set Point Lock prevents changes to your saved set point by deactivating the keypad

Specifications:

• Stand-alone unit uses common 9 VDC battery for operation. External 12/24 VDC and 110/120 VAC, 50/60 Hz power sources are available.
• Sleep Mode- Controller ‘goes to sleep’ for 5+ minutes between sampling pressure, resulting in extended battery life when used with 9 VDC battery.
• Small controller mounts almost anywhere!
• Circuit designed to new EMI electromagnetic interference) standards.
• 18 month warranty.
• UL pending.
• Patent pending.